Your cart
There are no more items in your cart
What is a Mosfet Regulator with Bypass
MOSFET Bypass
Out-of-Stock
€0.00
Tax included
What is a Mosfet Regulator with Bypass
Some harnesses are known to develop corrosion that increases electrical resistance, which in turn increases the temperature of the wires to the point where the connectors begin to melt. When this happens, the voltage regulator (and most likely the stator) will fail, resulting in high repair costs.
Our new bypass voltage regulator uses Mosfet technology designed to bypass the main wiring harness and connect the voltage regulator directly to the battery. This configuration has been shown to significantly increase the reliability of the voltage regulator.
Features
Mosfet Circuitry
Significantly reduces operating temperature for increased voltage regulator life. Provides a smoother, more stable signal to the battery.
Machined Aluminum Housing
Runs 33% cooler than standard die-cast voltage regulator housings.
PRO-FIT System
Includes everything needed to perform a professional RMSTATOR installation: connectors, harness side connectors & dielectric connector grease.
Before installing your new Mosfet voltage regulator rectifier:
Check the AC voltage of the stator
Replace all burned or corroded connectors on the voltage regulator rectifier and stator
Inspect and repair the harness
Use dielectric grease on all connectors
Details
Why use Mosfet technology?
Operating temperature
Operates at a much lower temperature than conventional regulators.
Fuel economy
Less resistance, less effort. The engine will necessarily use less fuel
Regulated power supply
The electrical supply is more uniform, more linear and without peaks.
Improved battery life
The electrical power that recharges your battery is more stable and will extend its life.
More engine power
A Mosfet type regulator will be able to deactivate all this wasted energy and will cancel the mechanical resistance transmitted to the engine.
Optimized Power
It can also optimize the amount of power transmitted by activating or deactivating the generator windings according to the electrical demand.
This ultra-reliable Mosfet design can handle up to 50 amps peak and 30 amps continuous 3-phase, 30 amps single-phase and operates at a lower temperature than all OEM diode regulators.
In addition, this rectifier has overheat protection, rather than "burning out", it turns off for a while to cool down.
A direct replacement for your original regulator
Plug-and-play, direct fit, easy installation
No assembly required
Highest grade of electronic components
Quality is superior to OEM equipment
All products shipped are checked
If in doubt, do not hesitate to compare our regulator to your original part, referring to our photos.
We include the opposite connector (main harness side) as we know that the connector is often melted/corroded/failed and is a major cause of electrical problems.
Also available for Lithium batteries and for some vehicles
No Related Stores
Tap to zoom
