Oxygen Sensor Yamaha SR Viper 1000 OEM 8JP-H592A-00-00 8JP-H592A-01-00

2016 Yamaha SR Viper 1000 XTX

2016 Yamaha SR Viper 1000 STX

2016 Yamaha SR Viper 1000 RTX

2016 Yamaha SR Viper 1000 MTX LE

2016 Yamaha SR Viper 1000 MTX

2016 Yamaha SR Viper 1000 LTX LE

2016 Yamaha SR Viper 1000 LTX

2015 Yamaha SR Viper 1000 XTX

2015 Yamaha SR Viper 1000 STX

2015 Yamaha SR Viper 1000 RTX LE

2015 Yamaha SR Viper 1000 RTX

2015 Yamaha SR Viper 1000 MTX LE

2015 Yamaha SR Viper 1000 MTX

2015 Yamaha SR Viper 1000 LTX LE

2015 Yamaha SR Viper 1000 LTX

2014 Yamaha SR Viper 1000 XTX

2014 Yamaha SR Viper 1000 RTX

OEM 8JP-H592A-00-00 8JP-H592A-01-00

There are no valid static tests to perform on the oxygen sensor. It should be diagnosed using an Auto Repair Software. First, verify that there are no stored codes for the oxygen sensor. The engine control unit must first run through the oxygen sensor time delay before a trouble code will be set so this may take several minutes at idle to occur.

Disconnect the harness going to the oxygen sensor. Remove the oxygen sensor from the exhaust pipe. Install new oxygen sensor to specification (torque: 13 ft-lb).Connect the harness going to the oxygen sensor.

Dimensions:
Width: 16,8 mm
Length: 60 mm
Height: 16,8 mm

Other specifications:
Number of plugs: 1
Number of terminals: 4